• Address: New York, NY 10271 (map)
• Date Posted: 11/05/09

I am selling this complete package for people who want the clean extra bass in their car which would retail at around $700. This package comes with:

* Visonik V108D4 10” 500 watt RMS competition subwoofer
* Clarion APX 1300 400 watt RMS amplifier
* Angled 10” Carpeted Box customized for this subwoofer
* 4 Gauge amplifier wiring kit
* 14 gauge speaker wire to hook the sub to the amp
* INSTALLCARD which will get this amplifier installed for free at thousands of locations across the country.

Reason for Selling – I bought all this stuff planning on installing it in my Jeep. My friend has this same exact sub/amp combo and it sounds amazing in his GMC Jimmy which is basically the same shape as my Grand Cherokee so I would definitely recommend this to people with an SUV. The problem for me is that I am now moving to New York City and I no longer need a car. Therefore I am also selling my car before I even got to install this system. I think this is a pretty good deal seeing as I bought all this stuff for a lot more.

REMEMBER everything is brand new and unused so you will be getting a brand new system and free installation for very cheap.

The subwoofer will come installed into the box and you will get an INSTALLCARD for the amp so therefore the only thing you will have to do is attach the speaker wire from the sub to the amp which would take about 5 seconds.

Below is the link for the diagram of how the setup will essentially look except I already did the hard part of wiring the sub into the box.

WIRING GUIDE:
http://akamaipix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_4-ohm_mono.jpg


SPECIFICATIONS OF EACH PRODUCT:


CLARION APX 1300 Mono Subwoofer Amplifier:
The Clarion APX1300 mono amplifier pumps out up to 400 watts RMS, with the versatility to work in a variety of systems. This mono amp delivers full-frequency response from 20 to 30,000 Hz, so you can use it to power a full-range speaker, or to drive a subwoofer system.
You can tune the APX1300 with its built-in variable low-pass filter and selectable bass boost for use in a sub system. Speaker-level and preamp-level inputs allow you to hook into almost any factory or aftermarket stereo. However you use it, this amp will supply your system with accurate, reliable power.
· Mono Car Amplifier
· 300 watts RMS x 1 at 4 ohms (400 watts RMS x 1 at 2 ohms) ß[will be wired at 2 ohms]
· variable low-pass filter (50-300 Hz, 12 dB/octave)
· selectable bass boost (0, 6, 12 dB at 50 Hz)
· Class-AB amplifier design
· MOSFET power supply
· CEA-2006 compliant
· speaker- and preamp-level inputs
· gold-plated connector terminals
· fuse rating: 20A x 3
· 8-gauge amp wiring kit with 60-amp fuse recommended ß[You get a 4 gauge amp wiring kit instead which is safer and delivers more power – the lower the gauge the more power it can handle]
· 13"W x 2-3/4"H x 10-7/8"D
Here is a link with some reviews (ALL 5-Star RATINGS):
AMP REVIEW: http://www.crutchfield.com/p_020APX1300/Clarion-APX1300.html?tp=115&tab=review

Company Profile of amp with retail price in top right corner:
http://www.clarion.com/us/en/products/2007/audio/amplifiers/APX1300/us-en-product-pf_1165294762681.html

The only note about this amp is that I bought it factory refurbished. Factory refurbished basically means that they made it new again so you do not have to worry about any problems


Visonik V108D4 10” Competition Series Subwoofer:

This is a brand new factory sealed Visonik V108D4, 10" competition subwoofer, which retail for $299.99 plus sales tax. This DVC subwoofer handles from 500 watts RMS to 1000 watts and is capable of producing dangerously high SPL levels! It is equipped with a large 90 oz. double stacked magnet and a die cast aluminum basket which provides better alignment, greater magnetic efficiency, and dissipates heat far better than steel allowing for increased power handling. It features a 10" spun acrylic cone woofer and a double treated high profile rubber surround which results into 25% more bass response and 30% more excursion. The dual laminated DuPont spiders and hyper-extended pole pieces provide for precise voice coil alignment. This sub has 4 ohm dual voice coils meaning a pair can be wired at 1 or 4 ohm load or a single at 2 or 4 ohms.
* 1000 Watts Power Handling
* 500 Watts RMS Power Handling
* Spun Acrylic Cone Woofer
* 90 oz. Double Stacked Magnet
* Vented Magnet Structure
* Die Cast Aluminum Basket
* Impedance: Dual 4 Ohms
* Dual 2.5" Aluminum Voice Coil
* Dual Laminated DuPont Spider
* Hyper-Extended Pole Piece
* Double Treated Foam Surround
* Chromed Die Cast Gasket
* Rubber Gasket
* Chrome Post Terminals
* Sensitivity: 84.9dB @ 1w/1m
* Mounting Depth: 5.56"
* Sealed Box: 0.5-1.0 Cubic Foot
* Suggested Retail: $299.99
Here is a link with some of the details and a more accurate price than the suggested retail:
SUBWOOFER PRICE: http://www.sunsetronics.com/customer/product.php?productid=1815&cat=0&page=1


10” MDF Subwoofer Enclosure
· Solid ¾" MDF Construction
· 0.85 Cubic Foot Sealed AIRTIGHT Chamber ß[Perfect for this sub which recommends 0.5 - 1.0 Cubic Feet]
· Dual Gold-Plated Speaker Terminals
· Show Quality Custom Carpet
· Dimensions (W x H x D): 13" x 13" x 13 3/4"
I had to sand the box down a little bit when it came because the subwoofer was so big it didn’t even fit in the hole!


4 Gauge Amplifier Wiring Kit:
· 17 foot Blue Power Cable
· 3 foot Black Ground Cable
· 15 foot Clear Speaker Cable
· 15 foot Red Remote Wire – 16 Gauge
· Split Loom for Cable Protection
· 80A Gold Plated Fuse – AGU Type
· Clear In Line Fuse Holder
· Power Ring Terminals, Cable Tie
This is a table showing the required gauge wiring kits for the distance of the wires and the amount of amp RMS power. The highlighted green shows 4 gauges for this set-up.

AMP RMS
Distance
Power
4 feet
8 feet
12 feet
17 feet
20 feet
100
10 gauge
10 gauge
8 gauge
8 gauge
4 gauge
200
10 gauge
8 gauge
8 gauge
4 gauge
4 gauge
400
8 gauge
8 gauge
4 gauge
4 gauge
4 gauge
600
8 gauge
4 gauge
4 gauge
4 gauge
4 gauge
800
4 gauge
4 gauge
4 gauge
2 gauge
2 gauge
1000
4 gauge
4 gauge
2 gauge
2 gauge
2 gauge
1400
4 gauge
2 gauge
2 gauge
2 gauge
2 gauge


Amplifier Installcard:

Not into "do it yourself" car stereo installations? No problem. With a pre-paid InstallCard, you can have your new amplifier (2-channel or mono) or equalizer installed by any professional who's a member of the InstallCard network — there are more than 1,500 locations all across the country. You'll get all the stuff in this package, plus the time savings and peace of mind that come with professional installation.
How does it work?
Simple. First, enter your zip code to see if there's an InstallCard installer in your area (if you don't see an installer listed, you may wish to call InstallerNet at the number listed below the zip code field. New installers are added to the network frequently, so there may be options available for you that aren't yet listed online). Then, just add this card to your online shopping cart, and proceed through checkout as usual. When you receive the card from us, visit www.installcard.com, enter the unique InstallCard number on the back of the card, and schedule your installation with the local shop.
Installation
When you arrive for your appointment at your local stereo shop, just hand over the InstallCard, and the invoice from when you registered it online, and your installation begins. And you can feel confident about the quality of work — every installer on the InstallerNet Network has at least two years' experience and is MECP (Mobile Electronics Certified Professional) certified. InstallerNet feels so strongly about the expertise of their installers, that they will warranty the labor of your installation for the life of your vehicle.
What does this card cover?
With this InstallCard a professional installer will install an external amplifier (2-channel or mono) or equalizer (EQ installations include power wiring) to an existing car stereo system. The installer will not provide RCA patch cables, or power and ground cables for amplifier installations (Don’t worry – I am including all of this so you don’t have to pay extra). Custom wiring options may cost extra, so be sure to ask your installer. Be sure to read the Details below to see what's covered. Please call an Advisor at 1-888-955-6000 if you have any questions.
Important note: This installation does not cover modifications to your vehicle. If modifications are required, you may be charged extra at the time of installation. Your installer will inform you of any additional charges before performing the work, so you can approve the charges.